NordicTrack N150 - Manual (Page 53)

YML14WN ADSL2+ Wireless N150 Modem Router User Guide
www.netcomm.com.au 53
NetComm Gateway Series - ADSL2+ Wireless N150 Modem Router
Telnet
I cannot telnet into the NB14WN.
STEPS CORRECTIVE ACTION
1 Check the LAN port and the other Ethernet connections.
2 Make sure you are using the correct IP address of the NB14WN. Check the IP address of the device.
3 Ping the NB14WN from your computer. If you cannot ping the device, check the IP addresses of the NB14WN
and your computer. Make sure your computer is set to get a dynamic IP address; or if you want to use a static
IP address on your computer, make sure that it is on the same subnet as the NB14WN.
4 Make sure you entered the correct password. The default password is “admin”.
5 If these steps fail to correct the problem, contact the distributor.
Web Configuration
I cannot access the web configuration.
STEPS CORRECTIVE ACTION
1 Make sure you are using the correct IP address of the NB14WN. Check the IP address of the device.
2 Make sure that there is not a console session running.
3 Check that you have enabled web service access. If you have configured a secured client IP address, your
computer’s IP address must match it.
4 For WAN access, you must configure remote management to allow server access from the Wan (or all).
5 Your computer’s and the NB14WN’s IP addresses must be on the same subnet for LAN access.
6 If you changed the devices LAN IP address, then enter the new one as the URL.
7 Remove any filters in LAN or WAN that block web service.
The web configuration does not display properly.
STEPS CORRECTIVE ACTION
1 Delete the temporary web files and log in again. In Internet Explorer, click Tools, Internet Options and then
click the Delete Files ... button. When a Delete Files window displays, select Delete all offline content and click
OK. (Steps may vary depending on the version of your Internet browser.)
Login Username and Password
I forgot my login username and/or password.
STEPS CORRECTIVE ACTION
1 If you have changed the password and have now forgotten it, you will need to upload the default
configuration file. This will erase all custom configurations and restore all of the factory defaults including the
password.
2 Press the Reset button for five seconds, and then release it. When the LINK LED begins to blink, the defaults
have been restored and the NB14WN restarts.
3 The default username is “admin”. The default password is “admin”. The Password and Username fields are
case-sensitive. Make sure that you enter the correct password and username using the proper casing.
4 It is highly recommended to change the default username and password. Make sure you store the username
and password in a save place.