NETGEAR Double 108 Mbps Wireless PC Card WG511U - Manual (Page 21)

User’s Manual for the NETGEAR Double 108 Mbps Wireless PC Card 32-bit CardBus WG511U
Basic Setup 3-3
August 2004
WG511U Default Wireless Configuration Settings
If this is a new wireless network installation, use the factory default settings to set up the network
and verify wireless connectivity. If this is an addition to an existing wireless network, you will
need to identify the wireless configuration and security parameters already defined.
Your WG511U factory default basic settings are:
• Wireless Network Name (SSID): NETGEAR_11g
Note: In order for the WG511U Wireless PC Card to communicate with a wireless access
point or wireless adapter, all devices must be configured with the same wireless network name
(SSID).
• Network Mode (Infrastructure or Ad-hoc): Infrastructure
• Data security WPA-PSK encryption: Enabled
• Default WPA-PSK passphrase: NETGEAR-ULTRA-G
The section below provides instructions for setting up the WG511U for basic wireless connectivity
to an access point. The procedures below provide step-by-step installation instructions for
Windows PCs. Use the procedure that corresponds to the version of Windows you are using.