NETGEAR Double 108 Mbps Wireless PC Card WG511U - Manual (Page 29)

User’s Manual for the NETGEAR Double 108 Mbps Wireless PC Card 32-bit CardBus WG511U
Basic Setup 3-11
August 2004
Verify wireless connectivity to your network.
a. Verify that your Connection and Status Monitor information matches your wireless
network.
b. Check the two LEDs on the WG511U:
c. Verify connectivity to the Internet or network resources.
Note: If you are unable to connect, see troubleshooting tips in the Basic Installation section of
the Reference Manual on the NETGEAR Double 108 Mbps Wireless PC Card 32-bit CardBus
WG511U Resource CD.
Table 3-2: LED Descriptions
LED 1
(below the
word
NETGEAR
on the left)
LED 2
(below the
word
NETGEAR
on the right)
Meaning
Slow blink OFF Power save mode (default from power up or reset)
Alternate
blink Alternate
blink Looking for network association
Power LED goes ON; Network LED is OFF; then Power
LED goes OFF and Network LED goes ON
Slow blink Slow blink Associated or joined with network; no activity
Fast blink Fast blink Associated or joined with network; blink rate increases
with activity on the network over the air or locally on the
network