Niles Audio ZR-4630s - Manual (Page 75)

67
SOURCE-POWER EDITING
These are the steps for editing the power ON/OFF
commands for the source components.
Step 1. Press and Hold the Program button.
The Program LED lights RED, the Source 2 LED lights
RED, Power/On LED Blinks RED, and the Enter IR
lights RED.
Edit Power for Source 2: Continue editing from Step 2.
Edit Power for Source 3: Tap the NEXT button until
the Source 3 LED lights RED, the Power/On LED
Blinks RED, and the Enter IR lights RED. Continue edit-
ing from Step 2.
Edit Power for Source 4: Tap the NEXT button until
the Source 4 LED lights RED, the Power/On LED
Blinks RED, and the Enter IR lights RED. Continue pro-
gramming from Step 2.
Step 2. If the component has a single power IR command
for both ON and OFF, teach the power IR command by
pressing the power button on the component's factory
remote.
or
If the component has a discrete ON and OFF com-
mand, teach the discrete ON command by pressing the
ON button on the source component's remote control.
The Enter IR light blinks.
Step 3. To test the command, press the TEST button. If
it does not operate the component as expected, teach
and test the command again until it does.
Note: Repositioning the remote control when teach-
ing the command can assist in capturing commands
accurately.
Step 4. Tap the NEXT Button. The Power/ON LED
turns OFF and the OFF LED Blinks RED.
Step 5. If the component has a single power command
for both ON and OFF, press the NEXT button again and
continue your programming of the system.
or
If the component has a discrete ON and OFF command,
teach the discrete OFF command.
The Enter IR light blinks.
Step 6. To test the command, tap the TEST button. If it
does not operate the component as expected, teach
and test the command again until it does.
Note: Repositioning the remote control when teaching the
command can assist in capturing commands accurately.
Step 7. Tap the program button to exit programming.
PROGRAM EDITING STEPS
IR COMMAND EDITING
These are the steps for editing the individual IR com-
mands for control of the source components.
Step 1. Press and Hold the PROGRAM button.
The Program LED lights RED, the Source 2 LED lights
RED, the Power/On LED Blinks RED, and the Enter IR
lights RED.
Edit IR Commands for Source 2: Tap the NEXT button
until the Source 2 LED lights RED, and the IR Commands
LED Blinks RED. Continue editing from Step 2.
Edit IR Commands for Source 3: Tap the NEXT button
until the Source 3 LED lights RED, and the IR Commands
LED Blinks RED. Continue editing from Step 2.
Edit IR Commands for Source 4: Tap the NEXT button
until the Source 4 LED lights RED, and the IR Commands
LED Blinks RED. Continue editing from Step 2.
Step 2. Press a function button on the Niles hand held
remote control that corresponds to the source-compo-
nent IR command you wish to teach.
The Enter IR lights RED.
Step 3. Using the source component's factory remote,
teach the IR command.
The Enter IR LED turns OFF.
Step 4. To test the command, press the TEST button. If
it does not operate the component as expected, repeat
steps 2, 3 and 4 until it does.
Note: Repositioning the remote control when teaching the
command can assist in capturing commands accurately.
Step 5. Repeat all steps until all the source-component
IR commands have been taught.
Step 6. Tap the PROGRAM button to exit programming.