Niles Audio ZR-4630s - Manual (Page 76)

PROGRAM EDITING STEPS
68
SEQUENCE EDITING
These are the steps for programming the Sequences for
control of the source components.
Step 1. Press and Hold the PROGRAM button.
The Program LED lights RED, the Source 2 LED lights
RED, the Power/On LED Blinks RED, and the Enter IR
lights RED.
Edit a Sequence for Source 2: Tap the NEXT button
until the Source 2 LED lights RED, and the Sequence
LED Blinks RED. Continue editing from Step 2.
Edit a Sequence for Source 3: Tap the NEXT button
until the Source 3 LED lights RED, and the Sequence
LED Blinks RED. Continue editing from Step 2.
Edit a Sequence for Source 4: Tap the NEXT button
until the Source 4 LED lights RED, and the Sequence
LED Blinks RED. Continue editing from Step 2.
Step 2. Press the keys on the Niles hand-held remote
that correspond to the commands you wish to include
in the sequence.
Note: Enter commands and delays in the order you
wish them to occur, using the Volume – or + keys to
include delays (Vol – = .5 sec, Vol + = 1 sec). As many
as 64 commands and/or delays may be included. The
Enter IR LED blinks when it receives a command.
Step 3. Press the PROGRAM button to exit programming.
STORING TUNER PRESETS
Step 1. Select the desired AM or FM band with the
Band Shift Button.
Step 2. Locate the desired station for preset, using the
Station Scan Buttons.
Step 3. Press and hold the Preset Button (for more than
three seconds) where you wish to store the currently
tuned station.
The station display blinks when the station is stored to
the Preset Button.
PROGRAM ERASING
Erasing Individual IR Commands
Step 1. Follow the same steps you would for the pro-
gramming of the IR command you wish to erase.
Step 2. When the Enter IR LED lights (prompting you to
teach an IR command), tap the ERASE button instead
of teaching a new IR command. The command that
was previously stored is now erased.
Step 3. Continue erasing or press the PROGRAM but-
ton to exit programming.
Erasing Individual Sequences
Step 1. Follow the same steps you would for the pro-
gramming of the sequence you wish to erase.
Step 2. When the Enter IR LED lights (prompting you
to enter the IR commands and/or delays for the
sequence), press the ERASE button instead of building
a new sequence. The sequence that was previously
stored is now erased.
Step 3. Continue programming or press the PROGRAM
button to exit programming.
Erasing all IR Commands and Sequence Programming
for Only One Source
Step 1. Press and Hold the PROGRAM button.
The Program LED lights RED, the Source 2 LED lights
RED, the Power/On LED Blinks RED, and the Enter IR
lights RED.
Erase all IR command and sequence programming for
Source 2: Continue programming from Step 2.
Erase all IR command and sequence programming for
Source 3: Quickly tap the NEXT button until the
Source 3 LED lights RED, and the Power/On LED
Blinks RED. Continue programming from Step 2.
Erase all IR command and sequence programming for
Source 4: Quickly tap the NEXT button until the
Source 4 LED lights RED, and the Power/On LED
Blinks RED. Continue programming from Step 2.
Step 2. While the source you wish to erase is lit (2, 3,
4, or TUNER), press and hold the PROGRAM and
ERASE buttons until the Power/ON, the IR Commands,
and the Sequence LEDs are all blinking.
Step 3. Release the PROGRAM and ERASE buttons,
and all programming for the selected source is erased.
Step 4. Continue programming, or press the PROGRAM
button to exit programming.