Nady Systems IRW-2PA User Manual

Page 6

Advertising
background image

(1) Battery Compartment/Cover
(2) Power Switch
(3) Power LED Indicator

(2)

(1)

(3)

1. Transmitter Set-up

Unscrew and remove the Battery Compartment Cover (1) by sliding it down off

the microphone to expose the battery holders. Insert 2 fresh AA alkaline batteries,

NiMH rechargeable batteries, or the optional IR-HBP battery pack while observing

the correct polarity as marked, and screw the cover back on the battery compart-

ment.

(Note: Make sure the transmitter is off when changing the batteries.)

2. Operation

a. Slide the Power Switch (2) to the ON position. The Power LED Indicator (1)

will light green, indicating that the transmitter is on. In the case of low batteries, the

indicator will be off, indicating that the batteries should be replaced with fresh ones

or the batteries should be recharged.

The IRW-2PA IR Reception LED Indicator (6) of the corresponding channel should

change from red to green if the sensors are properly receiving the signal. If it is

not, check the IRW-2PA power, sensor connections, and make sure the transmitter

is within range of the sensor. For optimum performance and range, make sure that

the IR emitter, at the base of the transmitter, is not covered by the hand and has an

unobstructed line-of-sight with the IR sensor.

b. While speaking into the microphone, increase the corresponding Volume Con-

trol (7) on the IRW-2PA to the desired level. The EQ Bass and Treble controls can

also be adjusted for audio preference. The microphone is now ready to use.

[Note: Observe care in selecting volume, transmitter location and speaker place-

ment so that acoustic feedback (howling and screeching) will be avoided.]

If there is no audio, check your speaker connections and verify proper impedance

is being used. If there is still no audio, try turning the IRW-2PA power switch on and

off in case the amp went into short-circuit protection mode due to accidental wiring

during speaker installation.

6

11

INSTALLATION

HT-6SC HANDHELD MICROPHONE TRANSMITTER

IR Sensor

IR Sensor

Nady

IRW-2PA

Speakers

Wireless Mic

Nady

IRW-2PA

Nady

Tru-Dispersion

Speaker

IR Sensor

IR Sensor

Advertising