NEC EXPRESS5800 N8800-099F - Manual (Page 109)

Procedures after Completion of Installation 5-13
CONFIRMATION OF THE GeminiEngine Control Software
VERSION
The following describes how to check the version of GeminiEngine Control Software, which
consists of various types of software for fault tolerance. Perform the procedure when you need to
check the GeminiEngine Control Software version of the current system before adding units or
attachment to NEC Express5800/ft series.
Confirm the version following the steps below:
1. Log in the system as an authorized Administrator.
2. Open Control Panel from the Start menu.
3. Open “Add or Remove Programs.”
You can confirm the version that corresponds to the name of [GeminiEngine Control
Software]. 㩷