NEC EXPRESS5800 N8800-099F - Manual (Page 69)

Windows Setup 4-17
5. The message, [Do you want to use the parameters
file in order to set up the Express server or
workstation?] is displayed. In case of using the
parameter file, select [Yes]. In case of not using,
select [No].
6. [NOTE] is displayed. Read
the displayed contents
carefully and select
[Confirm].
7. Cautions for Express Setup
are displayed. Read the
displayed contents carefully
and select [Confirm].
CHECK:
If OS is installed to the disk, the message that
confirms whether to continue the installation
is displayed. To continue the setup, select
[Continue].
8. In case of using the parameter file, the Configuration Diskette is required, so insert the FD
and select [Confirm].
In case of not using the parameter file, this message will not be displayed. Go to Step 9.
CHECK:
Do not remove the floppy disk that has been set
in this step until you receive instruction.
There is an existing partition on
this disk. Express Setup will
destroy any data in this partition.
Do you wish to continue?
Continue Cancel
Do you want to use the parameters file
in order to set up the Express server or
workstation?
No Yes
NOTE
We recommend you that you should save the information
proper to your system after system setup. If not, you will not be
able to recover the information. You can save the information
by the following process.
(1) Select ‘Tools’. (2) Select ‘Off-line Maintenance Utility
(3) Select ‘System Information Management’.
(4) Select ‘Save’.
Confirm
When the setup goes ahead, your system will be rebooted
some times automatically.
Please don’t remove the EXPRESSBUILDER CD-ROM and
the Configuration diskette until other directions appear.
Confirm
Insert configuration Diskette
Confirm Back