Network Technologies SM-nXm-C5AV-LCD - Manual (Page 39)

NTI VEEMUX AUDIO/VIDEO MATRIX SWITCH VIA CAT5
35
Appendix E- Rack mounting Instructions
This NTI switch was designed to be directly mounted to a rack. It includes a mounting flange to make attachment easy.
Install 4 cage nuts (supplied) to the rack in locations that line up with the holes (or slots) in the mounting flange on the NTI switch.
Then secure the NTI switch to the rack using four #10-32 screws (supplied). Be sure to tighten all mounting screws securely.
Note: Do not block power supply vents in the NTI switch chassis (if provided). Be sure to enable adequate airflow in
front of and behind the NTI switch.
Attach all cables securely to the switch and where necessary supply adequate means of strain relief for cables.
Figure 38- Mount Switch to a Rack
Grounding
These products have protective earth ground terminals and are built with full attention to consumer safety. There must be an un-
interruptible safety earth ground between the main power source and the product's power cord or supplied power cord set.
If ever the possibility exists for the grounding protection to have been reduced in any way, disconnect the power supply until the
grounding connection has been fully restored.
Servicing
NTI products are not intended to be serviced in the field and contain no user-serviceable parts. In the event repair is needed, all
servicing must be performed by factory trained and authorized service personnel. Only those items specifically identified in this
manual (if any) may be adjusted by the user of this product and adjusted only as instructed in this manual.
Cage Nuts
Rack Screws
Rack
(supplied) 10-32
(supplied)