NordicTrack Incline Trainer 9800 - Manual (Page 25)

24
The console will begin scanning all TV channels. If
no broadcast signal is detected on a channel, the
channel will be skipped; if a signal is detected, a
tone will sound and the channel will be stored in
memory. This process will continue until the high-
est channel is reached. The lowest channel stored
in memory will then appear in the main display.
Press the ENTER AGE button again and delete
or add TV channels.
After all valid TV channels have been stored in the
console’s memory, you can delete unwanted
channels or add other channels. To delete or add
a channel, first press the CHANNEL + and – but-
tons until the channel appears in the main display.
If the word DELETE appears beside the channel,
press the + or – button beside the ENTER AGE
button to delete the channel. If the word ADD ap-
pears beside the channel, press the + or – button
beside the ENTER AGE button to add the chan-
nel. Then, select the next channel that you want to
delete or add. Repeat this process until you have
finished deleting or adding channels.
Hold down the ENTER AGE button and the
RESET button simultaneously for two seconds
to exit the maintenance mode.
To exit the maintenance mode at any time, hold
down the ENTER AGE button and the RESET but-
ton simultaneously for two seconds.
HOW TO RESET THE LUBE REMINDER
If the words LUBRICATE DECK appear in the main
display when the maintenance mode is selected (refer
to step 9 on page 23), follow the steps below to reset
the lube reminder.
Insert the key into the console.
Refer to GETTING STARTED on page 14.
Hold down the STOP button and the RESET
button simultaneously for three seconds.
2
1 15
16