NordicTrack Incline Trainer 9800 - Manual (Page 9)

8
4. Thread two Upright Bolts (106) into each Upright (96,
107) in the indicated locations. Do not tighten the
Upright Bolts yet.
107
106
106
96 4
5. Next it will be necessary to adjust the incline of the
INCLINE TRAINER. First, plug in the power cord (refer
to page 10). Next, make sure that the on/off circuit
breaker is in the on position (refer to step 2 on page 14).
Place the Key (90) in the Console (89). Press the
QUICK INCLINE button labeled “21” to adjust the in-
cline to 21%. Then, remove the Key.
Move the on/off circuit breaker to the off position
and unplug the power cord.
6. Thread two additional Upright Bolts (106) into each
Upright (96, 107) in the indicated locations. Tighten all
eight Upright Bolts in the Uprights.
7. Refer to step 2 on page 7 and tighten the four Handrail
Bolts (93).
Place the Upright Caps (92) over the Handrail (94) and
the upper ends of the Uprights (96, 107). Press the
Handrail Caps against the hook-and-loop fastener strips
on the Uprights. Attach each Handrail Cap with four
Upright Cap Screws (91). Do not overtighten the
Upright Cap Screws.
90
89
QUICK INCLINE
buttons
107
106
106
106
92
94
91
91
96
107
91
91
96
92
5
6
7