NetComm NB3300 - Manual (Page 18)

www.netcomm.com.au Rev.1 - YML632
Page 18 ADSL Modem Router
Chapter 3: Internet Access
This chapter describes the procedures necessary to configure the basic functions and to start up
your NetComm ADSL Modem Router. On successful completion of these procedures, you will
be able to access the Internet via your NetComm ADSL Modem Router.
3-1 Prepare your network information
When setting up your NetComm ADSL Modem Router, in order to allow a quick reference
point, it is suggested you complete the table below with the necessary information which should
be supplied by your ISP:
Provided by some ISPs (
✓
tick indicates common minimal requirements)
Host Name: ______________________________________
Domain Name: ______________________________________
WAN/Public IP address given by ISP:
✓
❒
Dynamic
❒
Static
IP Address: _________._________._________._________
Subnet Mask: _________._________._________._________
Default Gateway: _________._________._________._________
DNS Server Primary:
✓
_________._________._________._________
DNS Server Secondary: _________._________._________._________
DNS Server Third: _________._________._________._________
VPI and VCI values:
VPI:
✓
______________________________________
VCI:
✓
______________________________________
Working mode:
✓
❒
Gateway using LLC Encap with Dynamic IP.
❒
Gateway using LLC Encap with Static IP.
❒
Gateway using Classical IP
❒
Gateway using PPPoE
❒
Gateway using PPPoA
❒
Router using Classical IP
❒
Modem using LLC Encaps.
PPP authentication:
Login Name:
✓
______________________________________
Password:
✓
______________________________________