NISSAN 2008 Altima Sedan - Manual (Page 189)

2. A list of commands appears on the screen,
and the system announces, “Please say a
command”.
3. After the tone sounds and the icon
on the screen changes from to gray to
orange, say “Command list”.
4. The system confirms the recognized
command, and a list of navigation com-
mands appears.
INFO:
● If the system did not recognize your
command, press the button or the
“Back” key to return to the previous screen.
● Voice commands cannot be accepted when
the icon is gray.
● If the command is not recognized, the system
announces, “Please say again”. Repeat the
command in a clear voice.
● Press the button or the “Back” key
once to return to the previous screen.
● If you want to cancel the command, press and
hold button for approximately 2
seconds. The message “Voice input is can-
celled” will be announced.
● If you want to adjust the volume of the system
feedback, press the volume control buttons +
or – on the steering wheel switch or use the
audio system volume knob while the system is
making an announcement.
How to say numbers
NISSAN Voice Recognition requires a certain
way to say numbers in voice commands. Refer to
the following examples. (General rule: Either
“zero” or “oh” can be used for “0”.)
Navigation:
Say commands according to the following ex-
amples:
● 2D map - “Two D map”
● Zoom level 5 - “Zoom level five”
WNV0552 WNV0553
Voice recognition 9-3
੬
REVIEW COPY— 2008 Altima (alt)
Navigation System OM—USA_English (nna)
03/06/07—arosenma
੭