Eizo 620L - Manual (Page 53)

8. PRACTICAL SETUP
8-1. 620L settings
By utilizing the DHCP Option function of the DHCP Server, necessary information are
supplied by the DHCP Server, and each setting is automatically set every time the 620L
is turned on.
The following information can be obtained by the eClient 620L.
• WTS/Web Server Connection Settings
• Automatic Software Update
• Security Settings
• Administration Console Setting
NOTE
• For DHCP Option settings, confirm the following:
- The eClient 620L is connected to the WTS/Web server through built-in LAN.
- A DHCP Server is used for obtaining the IP address.
• If you need to change the following settings from the defaults, please change them
before using the DHCP option function.
DHCP Server Settings
Please open DHCP settings to configure each DHCP Option as follows.
Items Contents
Key Set the value as “EIZO”. (The eClient 620L will not
accept any value but “EIZO”.)
Server Type an IP address of the Server installing an update
file and a registry file of the eClient 620L.
User Name / Password Type the user name to logon to the FTP Server.
Type the password for the user name.
Automatic Update Enable/unable an automatic connection.
File Name Type the file name to update the software of the
eClient 620L.
Automatic Connection Make a Registry File to connect to a WTS / Web
server (Refer to the NOTE below for the settings).
Security Setting Enable/unable the security settings.
Administration Console Type the IP address of the Server where Network
Administrator (eClient utility software) is installed.
8. PRACTICAL SETUP
53