New Transducers 42PF9830/10 - Manual (Page 52)

10
Configuring the wireless Ethernet
bridge
& Disconnect your PC from your network.
• In case of a wireless USB dongle, remove the
dongle from your PC.
• In case of an integrated wireless network adapter
(e.g. laptop PC), disable the network adapter.
• In case your PC has a wired connection, unplug the
Ethernet cable from your PC.
é Connect the wireless Ethernet bridge to your PC.
“ Consult the user manual supplied with the wireless
Ethernet bridge to configure your device.
The following settings need to be applied:
• Password (see access point documentation)
Note: Do not change any passwords at this time.
• Infrastructure (access point) mode
• SSID-name of your wireless network
• DHCP/Auto IP enabled
• Security encryption disabled
If your PC can connect to the Internet using a web
browser, the wireless Ethernet bridge is configured
correctly.
Notes:
- After configuring your wireless Ethernet bridge you may
need to wait a while before the connection is active.You
may even have to restart the bridge.
- How to restart the bridge, consult the user manual of
the bridge. The user manual will also explain the
meaning of the different indicators ( LEDs) on your
bridge and how they should behave after powering the
bridge.
- If you don’t succeed to browse the Internet using your
wireless Ehternet bridge, please contact the retailer of
the bridge (instead of Philips).
‘ Disconnect your wireless Ethernet bridge from the
PC and connect it to the
NETWORK connection at
the bottom of your TV.
( Reconnect your PC to your network.
Testing the wireless Ethernet bridge
& Make sure the wireless Ethernet bridge is connected
to the
NETWORK connection at the bottom of
your TV.
é Switch on your TV.
“ See “Testing your connection” on p. 9.
More details on configuring the
recommended wireless Ethernet bridges
can be found on the Philips support
website: www.philips.com/support