Neuton CE 6.2 - Manual (Page 15)

NEUTON CE 6.2 Battery-Powered Mower - Safety & Operating Instructions 11
Assembling Your NEUTON Mower
To allow you to quickly begin using your NEUTON Mower, it shipped to you partially assembled. The
assembly process is easy and does not require any special tools, knowledge, or strength.
Assembling your NEUTON Mower takes just a few steps:
Step 1: Read the Safety & Operating Instructions before proceeding
Step 2: Adjust the Handlebar Height
Step 3: Remove the Battery
Step 4: Charge the Battery before your first use
Step 5: Attach the Side Discharge Chute, Mulching Plug, or Rear Bagger
Step 6: Insert the Battery after it is fully charged
Each of these steps is described in detail below: (See Figure 15 on page 17 for a photograph of the
fully assembled Mower)
THE SAFETY KEY, WITH ITS BUILT-IN CIRCUIT BREAKER, AS WELL AS THE BATTERY, SHOULD NEVER BE
INSERTED DURING ASSEMBLY, ADJUSTMENTS, CLEANING, BLADE REPLACEMENT, OR WHEN THE MOWER IS
NOT IN USE. REMOVING THE SAFETY KEY WILL PREVENT ACCIDENTAL STARTING, AND HELP AVOID
SERIOUS PERSONAL INJURY.
Step 1: Read the Safety & Operating Instructions before proceeding.
The NEUTON Mower is a motorized cutting machine that uses a sharp Blade. For your safety, and for best
results, it is important to read the information in “Chapter 2: Important Safety Considerations” before you
assemble or use the Mower.
To familiarize yourself with the assembly, features, and operation of your Mower, please read the remainder of
this manual before proceeding.
NOTE: Do not discard the shipping box and packaging material until you are fully satisfied with your new
NEUTON Battery-Powered Mower.