Neuton CE 6.2 - Manual (Page 32)

28 1-866-NEUTON1 (638-8661) www.neutonpower.com
Charging the Battery
You must charge the Battery before using your Mower for the first time and after every use. You can
charge the Battery in or out of the Mower. The performance of your Mower is the same, regardless of
which charging method you choose.
WHILE THE BATTERY IN YOUR MOWER WAS CHARGED AT THE FACTORY, YOU MUST RECHARGE IT FULLY
(EIGHT (8) TO TWENTY-FOUR (24) HOURS) BEFORE USING YOUR MOWER. OTHERWISE, YOU MAY
DECREASE THE CHARGING CAPACITY OF THE BATTERY. AGAIN, USE ONLY THE CHARGER SUPPLIED WITH
THE MOWER.
As the Battery ages, you may need to charge the Battery longer, even up to twenty-four (24) hours. A
good time to consider purchasing a replacement Battery is when the Battery takes longer than
twenty-four (24) hours to charge.
USE NORMAL HOUSEHOLD VOLTAGE (110 VOLTS) WHEN CHARGING THE BATTERY. PLUG THE CHARGER
DIRECTLY INTO THE ELECTRICAL OUTLET. DO NOT ABUSE THE CORDS. NEVER CARRY THE CHARGER BY
THE CORD. ALWAYS PULL THE PLUG – AND NOT THE CORD – WHEN DISCONNECTING THE CORDS FROM
THE ELECTRICAL OUTLET (WALL OUTLET) AND FROM THE CHARGER.
NOTE: When using an extension cord with your Charger, use a heavy-duty extension cord of a type “suitable
for outdoor use” (although you should never charge the Battery in the open outdoors).
ALWAYS CONNECT THE CHARGER TO THE BATTERY FIRST, AND THEN PLUG THE CHARGER INTO THE WALL
OUTLET. WHEN UNPLUGGING, REVERSE THE PROCESS; UNPLUG THE CHARGER FROM THE WALL OUTLET
FIRST, AND DISCONNECT IT FROM THE BATTERY.
Charging the Battery in the Mower
1. Make sure all four (4) Wheels of the Mower touch the
floor.
2. Open the Access Cover and remove the Safety Key.
3. Remove the Protective Plug from the Charger
Receptacle on top of the Battery and plug in the round
Charger Connector Plug (Figure 24).
4. Plug the Charger into a wall outlet. The RED light on the
Battery will light up indicating a connection between
the Battery and Charger.
NOTE: A full charge takes at least eight (8) hours, and may take
up to twenty-four (24) hours. For the first five (5) hours,
the Charger will be warm to the touch. This is normal
and does not indicate a problem.
Figure 24
Charger in Mating Plug