Neuton CE 6.2 - Manual (Page 19)

NEUTON CE 6.2 Battery-Powered Mower - Safety & Operating Instructions 15
Installing the Bagger
1. Raise the Discharge Guard on your Mower
(Figure 10) and note the metal Support
Rod at the rear of the Mower.
2. Grasp the Bagger by the Top Handle
(Figure 11) and center it at the back of the
Mower.
3. Align the Metal Latch Hooks (Figure 11)
over the Support Rod (Figure 12) and
lower the Bagger in place until the Wire
Frame at the bottom of the Bagger rests
on the Mower.
4. Lower the Discharge Guard.
Removing and Emptying the Bagger
1. Raise the Discharge Guard.
2. Using the Top Handle of the Bagger, lift
the Bagger off the Support Rod and away
from the Mower.
3. Lower the Dischage Guard.
4. To empty the Bagger, tilt the Top Handle
forward. Use the Cloth Handle (Figure 13)
at the rear of the Bagger to move the
contents toward the front as you empty
the Bagger.
Figure 10
Discharge
Guard
Support Rod
Figure 11
Figure 12
Figure 13
Cloth Handle
Top Handle
Latch Hooks
Support Rod
Latch Hook
Latch Hooks