NAD C320BEE User Manual
Page 8
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
8
PROBLEM
CAUSE
SOLUTION
NO SOUND
•
Power AC lead unplugged or power not
switched on
•
Check if AC lead is plugged in and power
switched on
•
Tape 1 Monitor selected
•
De-select Tape 1 Monitor mode
•
Mute on
•
Switch off Mute
•
Rear Pre-out/Main-in amp links not fitted
•
Fit links
•
Headphones inserted
•
Disconnect headphones
NO SOUND ONE CHANNEL
•
Balance control not centered
•
Center Balance control
•
Speaker not properly connected or damaged
•
Check connections and speakers
•
Input lead disconnected or damaged
•
Check leads and connections
WEAK BASS / DIFFUSE STEREO IMAGE
•
Speakers wired out of phase
•
Check connections to all speakers in the system
REMOTE CONTROL HANDSET
NOT WORKING
•
Batteries flat, or incorrectly inserted
•
Check or replace batteries
•
IR transmitter or receiver windows obstructed
•
Remove obstruction
•
IR receiver in direct sun or very bright ambient
light
•
Place unit away from direct sun, reduce amount
of ambient light
POWER/PROTECTION LED TURNS RED
DURING OPERATION
•
Amplifier has overheated
•
Turn amplifier off, make sure ventilation slots on
top and bottom of amplifier are not blocked.
After amplifier has cooled down, turn back on
•
Overall impedance of loudspeakers too low
•
Ensure the overall loudspeaker impedance is not
below 4 ohms
TROUBLESHOOTING
C320BEE IM v2 29/8/02 11:02 pm Page 8