NordicTrack C2400 30703.0 - Manual (Page 16)

16
When the manual mode is selected, the console of-
fers eight display modes. The display mode that
you select will determine which workout information
is shown. For example, the first display mode
shows only the elapsed time and the distance that
you have walked or run. Press the Display button
repeatedly to select the desired display mode.
Note: Regardless of which display mode you select,
the speed or incline setting will appear in the dis-
play for a few seconds each time you change the
setting. In addition, your heart rate will appear in the
display for up to 40 seconds each time you use the
handgrip pulse sensor or put on the optional chest
pulse sensor. Note: If you select the display mode
shown below, your heart rate will be shown in place
of the approximate number of grams of carbs you
have burned.
As you exercise, the training zone bar will indicate
the approximate intensity level of your exercise. For
example, if eight of the indicators in the bar are lit,
the bar shows that your intensity level is ideal for
aerobic exercise.
To reset the console, press the Stop button, re-
move the key, and then reinsert the key.
7. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and the
optional chest pulse sensor at the same time, the
display will not show your heart rate accurately.
Before using the handgrip pulse sensor, remove
the sheets of clear plastic from the metal contacts.
In addition, make sure that your hands are clean.
To measure
your heart
rate,
stand on
the foot rails
and hold the
metal contacts
on the
handrail—
avoid moving
your hands.
When your pulse is detected, your heart rate will be
shown in the display.
For the most accurate heart
rate reading, continue to hold the contacts for
about 15 seconds.
8. Turn on the fan if desired.
The fan features low and high speed settings.
Press the Fan button repeatedly to select a fan
speed or to turn off the fan. Note: If the fan is on
when the walking belt is stopped, the fan will turn
off automatically after a few minutes.
9. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when you fold the treadmill to the storage posi-
tion, or you may damage the treadmill. Next, re-
move the key from the console and put it in a secure
place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord.
IMPORTANT: If you do
not do this, the treadmill’s electrical compo-
nents may wear prematurely.
Training Zone Bar
Contacts