NordicTrack C2400 30703.0 - Manual (Page 9)

9
9. Remove the indicated 3/4" Screw (7) from the
right Handrail (70).
See the inset drawing. Slide the Right Upright
Sleeve (9) up to the console assembly. Attach
the Right Upright Sleeve with two 1" Tek Screws
(82) and the 3/4" Screw (7) as shown.
Attach the Left Upright Sleeve (not shown) in
the same way.
9
7
7
70
82
Console
Assembly
8. Attach the console assembly to the Uprights
(85) with four Console Bolts (72) and four 3/8"
Star Washers (67) (only one side is shown).
Start all four Console Bolts before tightening
any of them.
67
72
85
Console
Assembly
8
11. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 28).
To protect the floor or car-
pet from damage, place a mat under the treadmill.
10. With the help of a second person, carefully lower
the Uprights (85) to a vertival position.
Attach the Right Base Cover (86) with three 3/4"
Screws (7) and two Base Cover Screws (63).
Start all five Base Cover Screws before tight-
ening them. Be careful not to overtighten the
Base Cover Screws. Attach the Left Base
Cover (88) in the same way.
With the help of a second person, carefully raise
the Uprights (85) to a vertical position.
63
7
88
86
63
7
85
10