NordicTrack C2400 30703.0 - Manual (Page 6)

1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its side as shown. Partially fold
the Frame (55) so that the treadmill is more sta-
ble.
Do not fully fold the Frame until the
treadmill is completely assembled.
Insert an Extension Leg (97) into the indicated
bracket on the base of the Uprights (85). Make
sure that the Extension Leg is turned so the Base
Pad (81) is on the side shown. If necessary, use
a rubber mallet to align the holes in the
Extension Leg with the holes in the bracket.
Attach the Extension Leg (97) with two Extension
Leg Bolts (87), two 5/16" Star Washers (110),
and two Extension Leg Nuts (91) as shown.
Firmly tighten the Extension Leg Bolts.
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex key and your own Phillips screwdriver , rubber
mallet and adjustable wrench .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the
key number of the part, from the PART LIST near the end of the manual. The number following the parentheses is
the quantity needed for assembly.
Note: Some small parts may have been pre-assembled. If a part is not in
the parts bag, check to see if it has been pre-assembled. To avoid damaging plastic parts, do not use
power tools for assembly. Extra hardware may be included.
6
123)–2
1/2” Silver Screw
(48)–1
3/4” Tek Screw (58)–4
3
3/4" Screw (7)–6
1" Tek Screw (82)–8
Washer (96)–8
Extension Leg Bolt (87)–4
5/16" Star
Washer (110)–4
Extension Leg
Nut (91)–4
E
3/8" Star
Washer (67)–4
Base Cover Screw (63)–4
Nut (20)–2
Console Bolt (72)–4
Latch Bolt (109)–2
85
Bracket
81
55
87
91
1
110
97