NordicTrack 831.159770 - Manual (Page 14)

14
26. Wrap the High Cable (73) around a 4” Pulley (35).
Attach the Pulley inside the slot in the Main
Upright (3) with a 3/8” x 2 1/2” Bolt (54), two 3/8”
Washers (55), two 5/8” x 1/2” Bushings (42), and
a 3/8” Nylon Jamnut (63).
26
55
42
63
3
35
42
55
54
73
27. Disassemble the pre-assembled Pulley Plates (31).
Wrap the High Cable (73) around a 4” Pulley (35)
in the direction shown. Attach the Pulley and a
Cable Trap (44) to the top set of holes in the end
of the Pulley Plates (31) with a 3/8” x 1 3/4” Bolt
(60) and a 3/8” Nylon Jamnut (63). Make sure
the Cable is in the groove of the Pulley and
that the Cable Trap is oriented to hold the
Cable in place.
27
73 60
44
35
31
63
28. Route the High Cable (73) up through the indicat-
ed slot in the Top Frame (1), over a 4” Pulley
(35), and back down through the Top Frame.
Attach the 4” Pulley (35) inside the slot in the Top
Frame (1) with a 3/8” x 2 1/2” Bolt (54), two 3/8”
Washers (55), two 5/8” x 1/2” Bushings (42), and
a 3/8” Nylon Jamnut (63).
28
1
35
42
55
54
63
42
73
55
Slot