NordicTrack 831.159770 - Manual (Page 20)

20
48. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on page 22 of this manual.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. If there is
any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE-
SHOOTING AND MAINTENANCE on page 25.
46. Attach the upper end of the Shroud (56) to the
two “L”-brackets on the Top Frame (1) with two
1/4” x 3/4” Bolts (17), two 1/4” Washers (71), and
two 1/4” Nylon Locknuts (25). Make sure that the
indicated corner of the Shroud is lined up with
the indicated corner of the Top Frame. The
Bolts must be inserted through the square
holes in the Shroud.
46
71
“L”-Brackets
1
25
17
Align
Corners
17
56
71
47. Attach the Curl Pad (21) to the Curl Post (83) with
four 1/4” x 3/4” Bolts (17).
83
17
17
21
47