NordicTrack 831.159770 - Manual (Page 17)

37. Route the end of the Low Cable (72) through the
indicated slot in the Main Upright (3).
Wrap the Low Cable (72) around a 4” Pulley (35).
Attach the Pulley inside the slot in the Main
Upright (3) with a 3/8” x 2 1/2” Bolt (54), two 3/8”
Washers (55), two 5/8” x 1/2” Bushings (42), and
a 3/8” Nylon Jamnut (63).
37
Slot
63
42 55
35
42
72
3
55
54
17
38. IMPORTANT: Follow the cables from end to
end; make sure that they are in the grooves of
the pulleys and that the cables and pulleys
move smoothly.
Thread the 1/2” Plain Nut (68) part way onto the
bolt at the end of the High Cable (73). Place the
1 1/2” Washer (40) on top of the Weight Tube
(36).
Insert the bolt on the High Cable (73) through the
ring on the Weight Pin (39) and into the threaded
hole in the Weight Tube (36). Tighten the bolt into
the Weight Tube until the Cables (73, 72, 76) are
tight.
Tighten the 1/2” Plain Nut (68) against the 1 1/2”
Washer (40).
38
Bolt
36
76
39
72
40
68
73
9
39. Open the parts bag labeled “ARM AND SEAT
ASSEMBLY.”
Attach a Seat (13) to the Seat Upright (37) with
four 1/4” x 3/4” Bolts (17).
Turn the Adjustment Knob (9) on the Main Upright
(3) counterclockwise to loosen it and pull it out as
far as possible. Slide the Seat Upright (37) into
the Main Upright. Release the Knob and let it
engage one of the adjustment holes in the Seat
Upright. Retighten the Knob.
13
3
17
37
17
39 Seat Assembly
Adjustment
Holes