Nortel Networks 03050 - Manual (Page 17)

Registering individual portables / 105
P0881594 Issue 02 MICS-XC Norstar-Companion Installer Guide
on page 106 to overwrite the system number then return to
step 2 of this procedure.
4. Press
s, then press m. The display shows
Registering....
5. Next, enter the Registration password when the display
shows Pswd:. The default is 7 2 3 4
6 (RADIO).
If the display does not clear after entering the password,
then you may be using the wrong password.
6. Wait for the display to clear. When it shows DN:, enter the
internal number (637-666) you want to assign to the
portable. When the display clears, it shows
Reg'n complete.
7. On the administration set, turn off registration in general
programming, Companion, subheading Registration.
To confirm that the C3020 is registered
1. To check that the portable has a dial tone, press
L.
If you hear a dial tone, go to step 2.
If you do not hear a dial tone, check that you have selected
the correct system number and press
Lagain. If you no
not hear dial tone try to register the portable again.
2. Make sure that the flap is closed and the Ringer Control
Switch is in the bottom position. Make sure the portable
telephone is idle and call forward is not active.
3. On a working telephone, dial the telephone number of the
registered portable.
If the portable rings, it is functioning properly.