Nortel Networks 03050 - Manual (Page 9)

Registering individual portables / 97
P0881594 Issue 02 MICS-XC Norstar-Companion Installer Guide
You can also press
⁄ to view the information in “standard”
display mode. This mode displays the radio ID of the Base
Station to which the portable is linked, followed by the
signal strength and power mode. For example, 15112 - 67
H . You can revert back to the initial display mode by
pressing
ƒ .
Hand-off does not occur as you move between the cell
boundaries. The link drops when you move out of range.
Note: In this example, the cell is 8, the card is 15, the port is
11, the radio is 2, and the channel is 29. The signal
strength measured by the Base Station is -67 dBm, and
the H indicates the portable is transmitting in high-
power mode (an L indicates low-power mode).
7. To end the connection, press
m.
Registering the C3050
The following section describes the procedures involved in
registering Companion C3050 portable telephones. To register
each portable with the Norstar system, you must do two things:
• Register the portables by entering the Registration
password on each one.
• Verify that the portable functions correctly.
C3050 Icons
Some C3050 portable telephone icons for Canada and the
United States are different but have the same functions. The
following table identifies these icons:
C3050 Canada Icon function C3050 US
Mute button
µ
«
Hang up button
´