National Instruments PXI-PCI 8330 Series - Manual (Page 14)

Chapter 2 Installation
© National Instruments Corporation 2-3 PXI-PCI 8330 Series User Manual
Figure 2-1. Installing the PCI MXI-3
Installing a PXI MXI-3 Card
You can install the PXI MXI-3 in any available 5 V slot in your PXI or
CompactPCI chassis.
1. Turn off your PXI or CompactPCI chassis, but leave it plugged in
while installing the PXI MXI-3 card. The power cord grounds the
chassis and protects it from electrical damage while you install the
module.
2. Install the PXI MXI-3 card:
• Secondary PXI MXI-3 card—Install the PXI MXI-3 in the
controller slot (Slot 1) of your chassis. This slot must support bus
arbitration and bus mastering. The secondary PXI MXI-3 contains
onboard logic that can operate only in such a slot.
• Primary PXI MXI-3 card—Choose any unused PXI or
CompactPCI 5 V peripheral slot except Slot 1. (Slot 1 is reserved
for the system controller.)
Warning To protect both yourself and the mainframe from electrical hazards, leave the
mainframe off until you finish installing the PXI MXI-3 card.
1 PCI Bus Slot
2 Cut-Outs
3 PCI Bus Card-Edge Connector
4 PCI MXI-3 Board
1
2
3
4