National Instruments cFP-20xx User Manual
Fieldpoint cfp-20 xx
Advertising
Quick Start Guide
FieldPoint cFP-20xx
What You Need to Get Set Up
•
cFP-20xx LabVIEW RT controller
•
Mounting hardware (DIN rail,
panel-mount, or rack-mount
accessory)
•
I/O module(s)
•
cFP-BP-x backplane, connector
blocks, cables
•
11–30 VDC power supply
•
Accessories: Ethernet cable,
number 2 Phillips screwdriver
•
PC running Windows
•
FieldPoint software 3.0.2 or later
•
LabVIEW RT
™
Advertising
Table of contents
Document Outline
- FieldPoint cFP-20xx Quick Start Guide
- What You Need to Get Set Up
- 1. Mount the Compact FieldPoint Backplane
- 2. Install the cFP-20xx Controller on the Backplane
- 3. Install I/O Modules on the Backplane
- 4. Install Connector Blocks on the Backplane
- 5. Connect the cFP-20xx to Your Network
- 6. Wire Power to the Compact FieldPoint System
- 7. Powering Up the cFP-20xx
- 8. Install Software on the Host PC
- 9. Configure the cFP-20xx
- Specifications
- Where to Go for Support