National Instruments cFP-20xx User Manual
Fieldpoint cfp-20 xx
Advertising
Table of contents
Document Outline
- FieldPoint cFP-20xx Quick Start Guide
- What You Need to Get Set Up
- 1. Mount the Compact FieldPoint Backplane
- 2. Install the cFP-20xx Controller on the Backplane
- 3. Install I/O Modules on the Backplane
- 4. Install Connector Blocks on the Backplane
- 5. Connect the cFP-20xx to Your Network
- 6. Wire Power to the Compact FieldPoint System
- 7. Powering Up the cFP-20xx
- 8. Install Software on the Host PC
- 9. Configure the cFP-20xx
- Specifications
- Where to Go for Support