National Instruments cFP-20xx - Manual (Page 10)

cFP-20xx Quick Start Guide 10 ni.com
2. Install the cFP-20xx Controller on the Backplane
1. Make sure that no power is connected to the controller.
2. Make sure that the cFP-20xx controller is right side up with the NI logo at
the top, and align the captive screws on the controller with the holes on the
backplane.
3. Seat the card edge at the back of the controller in the card-edge connector on
the backplane.
4. Press the controller firmly to seat it on the backplane.
5. Using a number 2 Phillips screwdriver with a shank of at least 64 mm (2.5 in.)
length, tighten the captive screws to 1.1 N · m (10 lb · in.) of torque.