Nortel Networks LIP-6812 - Manual (Page 9)

LIP-6812 User Guide
6 June 07
NOTE: Calls can not be received unless the Line is registered to a Call Server. When not
registered, the Line button LED will blink red and orange.
2.2. Making a Call
You can make a call using on-hook or off-hook dialing.
To place a call:
1) Lift the handset, press , press , or press Line button.
2) Dial the destination phone number; you may need to dial ‘#’ at the end of the number.
3) When the called party answers, begin speaking (the LCD will display the elapsed call time).
To end the call,
1) Replace the handset, press , press , press [EndC] Softkey, or press Line button.
2.3. Putting a Call on Hold
You can place a call in a waiting state; the held party cannot hear you and you cannot hear the
held party. You can answer or place other calls while a call is on hold.
To place a call on Hold:
1) Press the [Hold] Softkey.
To retrieve a held call:
1) Press the blinking Line button, or press [Rsum] Softkey.
NOTE: If multiple calls are on hold, a list of available calls will display. Use the [Prev]-[Next]
Softkeys to select the desired call, “Retrieve Call Idx. #”, and press the [ OK ] Softkey.
If you place a call on hold and return to idle, you may receive a Call Hold Ringback tone.
2.4. Transferring Calls, Announced
You can send an active call to another extension and either announce the call transfer or hang-
up to complete the transfer.
To transfer an active call:
1) Press the [Trns] Softkey.
2) Dial the number you wish to receive the transfer.
3) You may await answer and then hang-up, or just hang-up to complete the transfer.