Nortel Networks COMMUNICATION SERVER 1000 NN43021-110 - Manual (Page 45)

Hardware architecture 45
Table 5
Intelligent Peripheral Equipment cards (cont’d.)
Intelligent Peripheral Equipment cards
Number of
terminations
NT5K71 Extended CO Trunk card 4
NT5K72 E&M Trunk card 4
NT5K82 Extended CO Trunk card 8
NT5K83 E&M Trunk card 4
NT5K84 Direct Inward Dial Trunk card 8
NT5K90 Extended CO Trunk card 8
NT5K93 Extended CO Trunk card 8
NT5K99 Extended CO Trunk card 8
NT8D14 Universal Trunk card 8
NT8D15 E&M Trunk card 4
NTAG03 Extended CO Trunk card 8
NTAG04 Extended CO/Direct Inward Dial card 8
NTAG36 Meridian Integrated Recorded Announcement
card 8
NTCK16 Generic Extended Flexible CO card 8
Special:
NT5K20 Extended Tone Detector card 8
NT5K48 Global Extended Tone Detector card 8
NT5K92 Direct Inward Dial Tester card 1
Note: Terminal number (TN) density per segment is 16 to 128 TNs, with 64
to 512 TNs per IPE module. The maximum TN density assumes all slots
are equipped with NT8D02 Digital Line cards with 16 voice and 16 data TNs
provisioned. A typical mix of line and trunk cards yields a nominal density of 64
TNs per segment, 256 TNs per IPE module.
Intelligent Peripheral Equipment remote location
In a local operating environment, IPE can be housed up to 15.2 m (50 ft)
from the Common Equipment. IPE installed in a remote location extends
this range, allowing approximately 112.6 km (70 miles) between local and
remote facilities.
This extension is achieved by converting multiplexed loop signals to a form
compatible with the commonly used T-1 type digital transmission system.
Refer to
Table 5 "Intelligent Peripheral Equipment cards" (page 44) for a
list of IPE cards for use at the remote site.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Large System Overview
NN43021-110 02.05 Standard
30 September 2008
Copyright © 2003-2008 Nortel Networks
.