NETGEAR DG834GUV5 - Manual (Page 33)

DG834GUv5 Wireless Router with Built-in DSL Modem User Manual
Configuring Your Wireless Network and Security Settings 2-11
v1.0, May 2009
• Entering a PIN. For information about using the PIN method, see “Using PIN Entry to Add a
WPS Client” on page 2-12 .
Using a WPS Button to Add a WPS Client
Any wireless computer or wireless adapter that will connect to the modem router wirelessly is a
client. The client must support a WPS button, and must have a WPS configuration utility, such as
the NETGEAR Smart Wizard or Atheros Jumpstart.
To use the modem router WPS button to add a WPS client:
1. Log in to the modem router at its default LAN address of http://10.0.0.2 with its default user
name of admin and default password of admin, or using whatever LAN address and password
you have set up.
2. On the modem router main menu, select Add a WPS Client, and then click Next. The
following screen displays:
By default, the Push Button (recommended) radio button is selected.
3. Either press the WPS button on the side of the modem router, or click the onscreen button.
The modem router tries to communicate with the client for 2 minutes.
4. Go to the client wireless computer, and run a WPS configuration utility. Follow the utility’s
instructions to click a WPS button.
5. Go back to the modem router screen to check for a message.
The modem router WPS screen displays a message confirming that the client was added to the
wireless network. The modem router generates an SSID, and implements WPA/WPA2
Figure 2-4
WPS button