NETGEAR DG834GUV5 - Manual (Page 76)

DG834GUv5 Wireless Router with Built-in DSL Modem User Manual
5-6 Advanced Configuration
v1.0, May 2009
Using the Modem Router as a DHCP Server
By default, the modem router functions as a Dynamic Host Configuration Protocol (DHCP) server,
allowing it to assign IP, DNS server, and default gateway addresses to all computers connected to
the modem router’s LAN. The assigned default gateway address is the LAN address of the modem
router. IP addresses is assigned to the attached PCs from a pool of addresses specified in this
screen. Each pool address is tested before it is assigned to avoid duplicate addresses on the LAN.
For most applications, the default DHCP and TCP/IP settings of the modem router are satisfactory.
for an explanation of DHCP and information about how to assign IP addresses for your network.
Use Router as DHCP Server
If another device on your network will be the DHCP server, or if you will manually configure the
network settings of all of your computers, clear the Use Router as DHCP Server check box on
the LAN IP Setup screen. Otherwise, leave it selected.
Specify the pool of IP addresses to be assigned by filling in the Starting IP Address and Ending
IP Address fields. These addresses should be part of the same IP address subnet as the modem
router’s LAN IP address. Using the default addressing scheme, you should define a range between
10.0.0.3 and 10.0.0.254, although you might want to save part of the range for devices with fixed
addresses.
The modem router delivers the following parameters to any LAN device that requests DHCP:
• An IP address from the range you have defined.
• Subnet mask.
• Gateway IP Address is the router’s LAN IP address.
• Primary DNS server, if you entered a primary DNS address in the Basic Settings screen;
otherwise, the router’s LAN IP address.
• Secondary DNS server, if you entered a secondary DNS address in the Basic Settings screen.
Address Reservation
For more information, see
“Using the Modem
Router as a DHCP Server” on page 5-6 .
When you specify a reserved IP address for a computer on
the LAN, that computer receives the same IP address each
time it access the router’s DHCP server. Assign reserved IP
addresses to servers that require permanent IP settings.
Table 5-2. LAN IP Setup
Settings Description
See the online document listed in “Internet Networking and TCP/IP Addressing” in Appendix B