Nuvo T2 - Manual (Page 11)

IR Pass-Thru
The mini jack labeled “IR pass-thru" mini connection is
used for connecting forwarded IR signals to an audio
component connected to the auxiliary audio input.
Using the Aux. Input
The T2 is equipped with an auxiliary audio input labeled
“AUX IN.” This will accept an audio signal from an external
component. This is most useful as an additional local
source, or an additional source in a multi-zone audio
system.
The auxiliary input is a stereo RCA connection and
requires a standard RCA cable for the connection, fig. 4.
This must be enabled through the advanced menu, which
is accessed through the “Select Knob” on the face of the
T2 (see Menu Controls, AUX Input pg. 14) or in the T2
Configurator software (see Using the T2 Configurator
Software pg. 22). An additional advanced feature is the
ability to set the gain of the auxiliary signal to match the
output signal level of the T2.
Once the auxiliary input is enabled, it is selected from the
remote using the “AUX” button, fig. 5, or by pressing the
“Source” button for either Tuner A or Tuner B on the face
of the T2 and stepping through FM, AM, and WX (Weather
Band) to Aux. On the XM models the source button simply
toggles between XM reception and the auxiliary input,
fig. 6.
L L
OUT AUX IN
R R
TUNER B TUNER A
OUT
AUDIO
OUTPUT AUDIO
OUTPUT
ANTENNA INPUT
IN
USE ONLY NuVo
NV-T2PAS
POWERED ANTENNA SYSTEM TRIGGER
ON=+12V TRIGGER
ON=+12V
AUX IN
Auxiliary
Audio Source
Audio
Out
Fig . 4
Fig . 5
Fig . 6
1 2 3
4 5 6
7 8 9
0 ENT
AM FM
WX AUX
SCAN
ENTER
PWR A/B
HOLD
ALL OFF
PRE
SEEK
TUNE
CATEGORY
T2 Tuner
REMOTE CONTROL
DIR
TUNER
Model NV-T2DF
Dual FM/AM/WX Tuner
REMOTE
SENSOR
PUSH TO
ENTER
SELECT
1
6
2
7
3
8
4
9
5
0
<
<
DISPLAY MEMORY MENU PRE/DIR SOURCE ON-OFF
CATEGORY PRESET/DIRECT
Tuner A
STANDBY
FM STEREO•AM•WEATHER
Aux Input
Page 10