National Instruments PXI NI PXI-1052 - Manual (Page 35)

Chapter 2 Installation and Configuration
NI PXI-1052 User Manual 2-20 ni.com
You can use the Inhibit signal (active low) to power off the chassis. To
remotely power off the chassis, connect the Inhibit pin (pin 5) to a Logic
Ground pin (pins 1 or 9). As long as this connection exists, the chassis
remains off (standby). When you remove this connection, the chassis
powers on.
Note For the Inhibit signal to control the On/Off (Standby) state of the chassis, the front
power switch must be in the On (recessed) position.
Table 2-1. Remote Inhibit and Voltage Monitoring Connector Pinout
D-Sub Pin Signal
1 Logic Ground
2 +5 VDC
3 Reserved
4 +3.3 VDC
5 Inhibit (Active Low)
6 +12 VDC
7 Reserved
8 –12 VDC
9 Logic Ground
1 2 3 4 5
6 9 7 8