NAD C660 - Manual (Page 12)

GB
12
CONNECTIONS
Connections Chapter 2
PLAY DECK CONNECTIONS
OUTPUT JACKS
ANALOG
Connect the ANALOG CD PLAY OUT jacks to the CD input analog jacks on your receiver, preamp or
surround processor.
COAXIAL
Connect the COAXIAL CD PLAY OUT to the CD input coaxial jack of your receiver, preamp, processor or
external digital decoder.
RECORDING DECK CONNECTIONS
OUTPUT JACKS
ANALOG
Connect the ANALOG CD REC OUT jacks to the TAPE play/in jacks on your receiver, preamp or surround
processor.
COAXIAL
Connect the COAXIAL CD REC OUT jack to the coaxial play/in jack on your receiver, preamp, processor or
external digital decoder.
OPTICAL
Connect the OPTICAL CD REC OUT jack to the optical play/in jack on your receiver, preamp, processor or
external digital decoder.
INPUT JACKS
ANALOG
Connect the ANALOG CD REC IN jacks to the TAPE rec/out on your receiver or processor.
COAXIAL
Connect the COAXIAL CD REC IN jack to the coaxial rec/out jack on your receiver or processor.
OPTICAL
Connect the OPTICAL CD REC IN jack to the optical rec/out jack on your receiver or processor.
TO MAKE RECORDINGS FROM EXTERNAL DIGITAL SOURCES
• If your receiver does not have digital output jacks, you may connect the COAXIAL CD REC IN / OPTICAL
CD REC DIGITAL IN jacks on the unit directly to the coaxial/ optical rec/out jacks on your CD player or
other digital devices.
• If the CD player has both types of outputs, you may connect one to the input of your receiver and the
other directly to the unit.
IMPORTANT NOTES ON DIGITAL CONNECTIONS
Coaxial Connections
• Use a commercially available digital cable (or 75-ohm video cable).
• Do not use audio cords that are not appropriate for digital signal use.
Optical Connections
• Use a commercially available optical fibre cable.
• To ensure proper connection of optical cable, fully insert it into the jack until there is an audible click.
• Remember to save the plastic dust caps that cover the optical jacks, and replace them when a jack is
not in use to prevent dust from entering the connection point.
Using the DIGITAL IN (OPTICAL)
jack on the front panel
Connections to a portable digital CD
or MD player may be made by
connecting the digital output of the
player to the front panel DIGITAL IN
(OPTICAL) jack on this unit.
NOTE
Consult the owner’s manual on
your receiver or processor for
details, as the names of the jacks
may vary from unit to unit.
POWER CONNECTIONS
Connect the AC Power Cord to an
AC power source.
USING HEADPHONES
Connect headphones with a stereo
standard plug (ø 6.3 mm) to PHONES.
• When the unit is in the dual
playback mode (see page 26),
only the output of the play deck
will be fed to PHONES jack.
A-1
A-2
B-1
B-2
B-3
C-1
C-2
C-3
C660 manual 27/2/01 6:03 pm Page 12