NETGEAR CA 95054 User Manual
Page 17
NETGEAR Router Setup Manual
Connecting the Router to the Internet
3-5
August 2004
Figure 3-5: Router welcome screen
In its factory default state, the router will display the NETGEAR Smart Wizard welcome
page.Click OK to proceed.
Note: If you do not see this page, type
http://www.routerlogin.net in the browser address bar and click Enter.
If you still cannot connect to the router, verify your computer networking setup. It should be
set to obtain both IP and DNS server addresses automatically, which is usually so. For help
with this, please see the Reference Manual or animated tutorials on the CD.
2.
Follow the Smart Wizard prompts to connect to the Internet.
Note: The configuration assistant only appears when the router is in its factory default state.
After you configure the router, it will not appear again. You can always connect to the router
configuration menu to change its settings. To do so, open a browser and go to
http://www.routerlogin.net. Then, when prompted, enter admin as the user name and
password for the password both in lower case letters.
You are now connected to the Internet!