Appendix b: troubleshooting – NetComm Power Over Ethernet NPPOE1001 User Manual
Page 11
YML720 Rev1
NetComm NPPOE1001 Power over Ethernet Kit
www.netcomm.com.au
11
In a straight-through cable, wires 1,2,3,4,5,6,7 and 8 at one end of the cable are still wires 1~8 at the
other end. In a crossover cable, the wires of 1,2,3,6 are reversed so that wire 1 become 3 at the other
end of the cable, 2 becomes 6, and so forth.
To determine which wire is wire 1, hold the RJ-45 cable tip with the spring clip facing towards the
ground and the end pointing away from you. The copper wires exposed upwards to your view. The
first wire on the far left is wire 1. You can also refer to the illustrations and charts of the internal
wiring on the following page.
Straight-Through Cabling
Wire
Becomes
1
1
2
2
3
3
6
6
Cross-Over Cabling
Wire
Becomes
1
3
2
6
3
1
6
2
Note:
To prevent loss of signal, make sure that the length of any twisted-pair
connection does not exceed 100 metres.
RJ-45 Connector
Pin Assignment
Normal Assignment
1
Input Receive Data +
2
Input Receive Data -
3
Output Transmit Data +
6
Output Transmit Data -
4,5,7,8
Power - PoE pins