NetComm Power Over Ethernet NPPOE1001 - Manual (Page 5)

YML720 Rev1 NetComm NPPOE1001 Power over Ethernet Kit
www.netcomm.com.au 5
Installation
This chapter describes the function of the Power-over-Ethernet Adapter Kit and shows how to install
it on your network.
Basic knowledge of networking is assumed. Read this chapter before you proceed.
The POE Injector
The PoE Injector mixes data and power into the RJ-45 connector and then transmits power and data
over the Cat5 cable to the PoE (direct connection) compatible device or PoE Splitter. This Injector
inputs 48 Volts DC into the PoE system.
Figure 1
Injector
Object Description
Injector
PWR LED Lights green to indicate that the power has been supplied
to the device
Power and Data Out Port Connects the RJ-45 port of Splitter through Cat 5
Ethernet cable
DC Jack Connects to the power adapter for receiving power - 48
Volts DC.
Cat 5 Ethernet Cable Connects to other network devices