Adding a static route – Netopia R2020 User Manual
Page 159
Multiple Network Address Translation and IP Setup 10-33
Priority: An indication whether the Netopia R2020 will use the static route when it conflicts with information
received from RIP packets.
Enabled: An indication whether the static route should be installed in the IP routing table.
Adding a static route
To add a new static route, select Add Static Route in the Static Routes screen and go to the Add Static Route
screen.
■
To install the static route in the IP routing table, select Static Route Enabled and toggle it to Yes. To
remove the static route from the IP routing table, select Static Route Enabled and toggle it to No.
■
Be sure to read the rules on the installation of static routes in the IP routing table. See
route installation” on page 10-34
.
■
Select Destination Network IP Address and enter the network IP address of the destination network.
■
Select Destination Network Subnet Mask and enter the subnet mask used by the destination network.
■
Select Next Gateway IP Address and enter the IP address for the router that the Netopia R2020 will use to
reach the destination network. This router does not necessarily have to be par t of the destination network,
but it must at least know where to for ward packets destined for that network.
■
Select Route Priority and choose High or Low. High means that the static route takes precedence over RIP
information; Low means that the RIP information takes precedence over the static route.
■
If the static route conflicts with a connection profile, the connection profile will always take precedence.
■
To make sure that the static route is known only to the Netopia R2020, select Advertise Route Via RIP
and toggle it to No. To allow other RIP-capable routers to know about the static route, select Advertise
Route Via RIP and toggle it to Yes. When Advertise Route Via RIP is toggled to Yes, a new item called RIP
Metric appears below Advertise Route Via RIP.
Add Static Route
Static Route Enabled: Yes
Destination Network IP Address: 0.0.0.0
Destination Network Subnet Mask: 0.0.0.0
Next Gateway IP Address: 0.0.0.0
Route Priority... High
Advertise Route Via RIP: No
ADD STATIC ROUTE NOW CANCEL
Configure a new Static Route in this Screen.