Netopia R2020 User Manual
Page 25
Making the Physical Connections 2-3
If you have two phone lines on a single wall outlet, this is the only Telco connection you need to make. The
pinout configuration for the lines on the Line 1 por t is shown in the following diagram:
Your first Telco number is carried on the inner pair and the second number on the outer pair.
3.
If you have a second phone line with its own separate wall outlet, and want to use both built-in modems,
connect one end of one of the RJ-11 cables to the “Line 2" por t, and the other end to your second wall
outlet.
4.
Connect the Ethernet cable to any of the Ethernet por ts on the router.
(If you are connecting the router to an existing Ethernet hub, use Ethernet por t #1 on the router and set the
crossover switch to the Uplink position.)
You should now have: the power adapter plugged in; the Ethernet cable connected between the router and
your computer; and the telephone cables connected between the router and the wall outlets.
5.
Inser t your Netopia CD and follow the instructions to install an Internet browser and the Adobe Acrobat
Reader, if you don’t already have them.
6.
Now, run the Smar tStar t application.
Smar tStar t requires the following:
■
your computer must be Ethernet-capable, that is it must have both an Ethernet card and TCP/IP stack
software. See
“Before running Smar tStar t” on page 3-1.
■
your computer and the Netopia R2020 are powered ON.
■
the computer running Smar tStar t and the Netopia R2020 to be configured must be on the same Ether-
net segment; there can be no inter vening routers. Repeaters, such as 10Base-T hubs, are acceptable.
“Setting up your Router with the Smar tStar t Wizard” on page 3-3
for details on running
Smar tStar t.
1
2
3
4
Telco 1
Telco 2
5
6
7
8