Installing pap, Local, Remote via adlm – Network Equipment Technologies 500 User Manual

Page 14: Installing pap, 2-2, Local, 2-2 remote via adlm, 2-2, Isdn

Text mode
Original mode

Advertising

10003137.00 Rev.1

2-2 Installing PAP

Installing PAP

PAP can be used to monitor traffic on either a local or a remote PrimeSwitch.

Local

To monitor local traffic connect the PC to the PrimeSwitch PAP connector, as in the
following diagram:

Figure 2: Local connection

Remote via ADLM

To monitor remote traffic, a V.24 ADLM must be installed in both the local and remote
PrimeSwitches. Connect the PAP connector to an ADLM V.24 port on the remote
PrimeSwitch, and connect the PC to an ADLM V.24 port on a local PrimeSwitch, as in
Figure 3:

Figure 3: Remote connection

PrimeSwitch

PAP

Local PrimeSwitch

Remote PrimeSwitch

ISDN

ADLM

PAP