Network Equipment Technologies 500 - Manual (Page 17)

Installation 2-5
Connecting PAP to a PC
Connect the PrimeSwitch PAP protection device to a parallel port of the PC.
To monitor local traffic:
1 Connect COM1 or COM2 on the PC to the 25-way D type connector on the
PrimeSwitch PAP panel using a straight through cable constructed according to Figure
5.
Figure 5: Local cable construction
To monitor remote traffic:
1 Connect the PC to an ADLM V.24 port on the local PrimeSwitch using a cable
constructed according to Figure 6.
Figure 6: Remote cable construction
3
7
2
3
7
2
OR
3
2
5
DB 25 Female
(to PC)
DB 25 Male
(to PAP V.24 por t)
DB 9 Male
(to b uilt-in P AP por t)
3
7
2 3
7
2
OR
2
3
5
DB 25 Male
(to ADLM V.24 por t)
DB 25 Female
(to PAP por t)
DB 9 Male
(to b uilt-in P AP por t)