6 setup > logs 14-7 setup > alarms, 6 setup > logs, 7 setup > alarms – Navman 5505 User Manual

Page 49

Advertising
background image

TRACKER 5505/5505i/5605 Installation and Operation Manual

49

NAVMAN

14-6 Setup > Logs

Press

one or more times until the

Setup

menu is displayed, then select

Logs:

The values can be changed independently of
each other. These log values are saved when
the unit is turned off.
Reset trip dist
This resets the trip distance to zero.
Reset total dist
This option resets the total distance to zero.
Reset engine hours
Use this option to reset the engine hours
to zero. This can be useful after an engine
service or to count the engine hours between
service intervals.

14-7 Setup > Alarms

Press

one or more times until the

Setup

menu is displayed, then select

Alarms:

All alarms except

Loss of GPS fix

can be

turned on (enabled) or off (disabled).

Symbol

Alarm

Alarm sounds when it is on and the:

Arrival

boat is closer to the destination or to a waypoint

radius

than the alarm trigger value

Anchor alarm

boat moves by more than the alarm trigger value

XTE

boat moves off course by more than the CDI scale

(see section 14-2)

Danger

boat comes closer to a danger waypoint than

the alarm trigger value

Low fuel

Low fuel fuel remaining equals the alarm trigger value; on a multi-tank

boat you can set separate alarms for each tank (see section 10-4)

Loss of

TRACKER can not receive the DGPS signal

DGPS fix

(beacon, WAAS or EGNOS)

Loss of

TRACKER can not receive the GPS signal

GPS fix

(this alarm is always on)

For the

XTE

and

Loss of DGPS fix

alarms, select to turn the alarm on or select

to turn the alarm off. For the other alarms,

enter a trigger value to turn the alarm on. The
alarm will sound each time the alarm value
equals the trigger value. For example, the

Danger

alarm will sound if the boat comes

closer to a danger waypoint than the trigger
value and the

Anchor

alarm will sound if the

boat moves by more than the trigger value. To
turn these alarms off, enter a trigger value of
0 (zero).
Icons for alarms that are on can be displayed in
the data header (see section 2-8-2). An alarm
icon is normally black and turns red when the
alarm sounds.

Advertising