Network Technologies DVI-x - Manual (Page 8)

NTI UNIMUX SERIES USB KVM SWITCH
5
INSTALLATION
1. It is not necessary to turn the CPUs or monitors OFF during this installation.
2. Connect a HDMI-to-DVI cable (supplied) from a DVI monitor to the HDMI connector labeled with a monitor symbol ( )
on the front of the UNIMUX (See Fig. 3 below.)
Figure 3- Connect a DVI monitor
3. Connect the male USB type A connector on the keyboard cable to either one of the two USB type A female connectors
labeled with the USB symbol ( ) on the front of the UNIMUX.
4. Connect the male USB type A connector on the mouse cable to the remaining USB type A female connector labeled with the
USB symbol on the front of the UNIMUX.
Figure 4- Connect the device(s)
DVI Enabled
Monitor
Mating Face of
DVI Male
Mating Face of
HDMI Type A Male
DVI-HDMI-MM-3
(supplied)
8 7 6 5 4 3 2 1
Scan Command Broadcast
UNIMUX TM
RS232
DDC
NTI
R
Ne twork Tech nolog ies Inc
1 8
ON
Front View of UNIMUX-DVI-8
USB Keyboard
USB
Mouse
USB Type A
Male Connectors
USB Type A Male
USB Type A Female
8 7 6 5 4 3 2 1
Scan Command Broadcast
UNIMUX TM
RS232
DDC
NTI R
Ne two rk Technologies Inc
1 8
ON
Front View of UNIMUX-DVI-8