NISSAN 40053 - Manual (Page 25)

25 ‘04-’09 Nissan Titan - Kit 40053
e. Mark and cut frame crush zone driver and pas-
senger side as shown.
f. Position front bumper on frame crush zone and
check for interference. Trim as little as neces-
sary.
g. Install two brackets on front bumper with four
bolts and nuts.
h. Install kit edge trim on the cut edge of the front
bumper.
i. Install front bumper on front bumper brackets
and vehicle with four top bolts. Do not tighten.
Frame Crush
Zone
Mark & Cut
Frame
Crush Zone
Mark & Cut
Before
After
Bolts, Nuts
Bracket
Front
Bumper
Bolt
Front
Bumper
j. Install front bumper and two kit spacers on front
bumper brackets with two kit bolts (M8-1.25 X
40mm). Do not tighten.
k. Install four nuts and two side impact braces on
front bumper.
l. Install two side impact braces on two kit brack-
ets, side impact with four kit bolts (3/8” x 1”),
eight kit washers (3/8” USS), and four kit nuts
(3/8” nylock).
m. Install two kit brackets, side impact on frame
with four bolts.
n. Remove eight grill turn clips from core support.
Install eight grill turn clips on grill.
Kit Spacer
Front
Bumper
Front
Bumper
Bracket
Kit Bolt (M8 -1.25
X 40mm)
Kit Edge
Trim
Side Impact
Braces
Nuts
Front
Bumper
Kit Bracket,
Side Impact
Bolt
Side Impact Braces
Kit Bolt (3/8” x 1”), Kit
Washer (3/8” USS), & Kit
Nut (3/8” Nylock)
Frame