NISSAN 40053 - Manual (Page 29)

29 ‘04-’09 Nissan Titan - Kit 40053
a. Connect both battery cables. Connect positive
cable first, then negative cable.
Miscellaneous
1. Apply kit label (warning) to dashboard in plain sight
of all vehicle occupants.
2. Adjust headlights.
3. Check all fasteners to ensure they are tight.
4. Ensure all wires, hoses, cables, etc. are properly
connected and there is ample slack.
5. Start engine and top off cooling system. Purge air
from cooling system according to manufacturer’s
instructions. Install radiator cap.
WARNING
If the engine cooling system is hot, the coolant will be
HOT and UNDER PRESSURE. To prevent serious
personal injury, wait until the cooling system is com-
pletely cool before removing the cap from the radiator.
Negative
Cable
Positive
Cable
Battery
Dynamic Vehicle Check
1. Test-drive vehicle. Check steering in both directions
to ensure that there is no bind. Check operation of
clutch, brake system, and parking brake. Check
operation of transmission and transfer case. Ensure
there is full engagement in all gears and 4WD
ranges. Check battery connections and electrical
component operations..
WARNING
Retorque all fasteners after 500 miles and after off road
use. All body lift components should be visually
inspected and fasteners retorqued during routine vehi-
cle servicing.
CAUTION
Performance Automotive Group does not recommend
any particular wheel and tire combinations for use with
its body lifts and cannot assume responsibility for the
customer’s choice of wheels and tires. Refer to your
owner's manual for recommended tire sizes and warn-
ings related to the use of oversized tires. Larger wheel
and tire combinations increase stress and wear on
steering and suspension components, which leads to
increased maintenance and higher risk for component
failure. Larger wheel and tire combinations also alter
speedometer calibration, braking effectiveness, center
of gravity, and handling characteristics. Consult an
experienced local off road shop to find what wheel and
tire combinations work best with your vehicle.
NOTE
All warranty information, instruction sheets, and other
documents regarding the installation of this product
must be retained by the vehicle owner. Information
contained in the instructions and on the warranty card
will be required for any warranty claims. The vehicle
owner needs to understand the modifications made to
the vehicle and how they affect vehicle handling and
performance. Failure to provide the customer with this
information can result in damage to the vehicle and
severe personal injury.
NOTE
Depending on the vehicle configuration (automatic or
manual transmission, 2WD or 4WD, cab length, bed
length, etc.), some parts may not be used.