Route calculation and visual guidance -6, Route calculation and visual guidance – NISSAN 2009 Altima Coupe User Manual

Page 223

Advertising
background image

Symptom

Possible cause

Possible solution

Waypoints are not included in the auto reroute
calculation.

Waypoints that you have already passed are not included in the
auto reroute calculation.

If you want to go to that waypoint again, you need to
edit the route.

Route information is not displayed.

Route calculation has not yet been performed.

Set the destination and perform route calculation.

You are not driving on the suggested route.

Drive on the suggested route.

Route guidance is set to off.

Turn on route guidance.

Route information is not provided for certain types of roads (roads
displayed in gray).

This is not a malfunction.

The auto reroute calculation (or detour calculation) sug-
gests the same route as the one previously suggested.

Route calculations took priority conditions into consideration, but
the same route was calculated.

This is not a malfunction.

A waypoint cannot be added.

Five waypoints are already set on the route, including ones that you
have already passed.

A maximum of 5 waypoints can be set on the route. If
you want to go to 6 or more waypoints, perform
route calculations multiple times as necessary.

The suggested route is not displayed.

Roads near the destination cannot be calculated.

Reset the destination to a main or ordinary road, and
recalculate the route.

The starting point and destination are too close.

Set a more distant destination.

The starting point and destination are too far away.

Divide your trip by selecting one or two intermediate
destinations, and perform route calculations multiple
times.

There are time restricted roads (by the day of the week, by time)
near the current vehicle location or destination.

Set the “Use Time Restricted Roads” key to off.

“SETTING CONDITIONS FOR THE
ROUTE CALCULATION” (page 5-10)

A part of the route is not displayed.

The suggested route includes narrow streets (roads displayed in
gray).

This is not a malfunction.

The part of the route that you have already passed is
deleted.

A route is managed by sections between waypoints. If you passed
the first waypoint, the section between the starting point and the
waypoint is deleted. (It may not be deleted depending on the area.)

This is not a malfunction.

ROUTE CALCULATION AND VISUAL
GUIDANCE

11-6

Troubleshooting guide

REVIEW COPY—

2009 Altima (alt)

Navigation System OM—USA_English (nna)
05/22/08—debbie

Advertising